This is needed to have your remote paired with your RC satellite-receiver.
- Power off your remote
- Connect the satellite receiver to the normal RC receiver.
- Plug the bind bridge in the bing plug of the receiver
- Plug one speed controller signal to the thrust plug of the receiver
- Plug a battery in the end of the Y
- Both satellite receiver and normal receiver led should blink
- Press the bind button of the remote (at the back)
- Power on the remote, while keeping bind button pressed until the led stop blinking and remain on.
- Release the bind button
- The remote should make a noise
- Power off the remote
- Unplug the battery
- Remove the bind bridge from the receiver plug
- Motor thrust calibration:
- Connect the satellite receiver to the normal RC receiver.
- Plug one speed controller signal to the thrust plug of the normal receiver
- Power on your remote
- When the remote is ready, put full thrust
- Plug a battery in the end of the Y
- The speed controller will beep twice
- Put the thrust down on the remote
- The speed controller will beep three times.
- Do the same for the 3 other motors